Quote:
Originally Posted by BzsBimmer
Please do not use your same bolts. These are TTY bolts and should be new.
Do it right or don’t do it at all.
You can find torque + angle through ISTA IIRC
|
many thanks for reply. will try to describe reason, the car has 12k miles, I owner, so car engine was tested on auction if it runs or not and due to car was w/o thermostat during start all oil was thrown out, as I assume engine was running few seconds but enough for doubts, after purchase when I drain remaining oil there was about 2 ltr of old oil.... after oil and filter replacement car was running 50 km or less. I open engine cover due to valvetronic motor has fault. we found that intake camshaft needs replacement, however oil filter is clean w/o any metal particles. that's why I want to know condition of rod bearings.