Thread
:
Evo rear spoiler restoration project
View Single Post
01-23-2011, 09:27 PM
#
11
Nachos23
HotBimmer
36
Rep
112
Posts
Drives: 2016 335GT & 2000 Z3M Roadster
Join Date: Jan 2011
Location: Whitby, ON, Canada
iTrader: (
1
)
Garage List
2016 BMW 335GT
[0.00]
2000 BMW Z3M
[0.00]
Setting the gun is the biggest challenge now! Have a decent compressor running it.... 60 gallon, 18.5 cfm @ 100psi; Tsunami 3-stage filtration and a DeVilbiss GFG-670 Cup feed. One drawback is I'm running 1/4" pipes.... Need to install the 1/2" manifold and 5/8 high flow fittings. I've had the parts for the manifold on the floor for the last 4 months; been crazy..... Takes a while to setup gun each time... Have test pieces I spray to check flow, etc before spraying anything to be finished.....
Here's a couple of pics of my car:
The rubber @ top pf lip was just until I properly fitted it.... Notice it's gone in the above picture......
After installation of a DCT shifter and transferring all functions, I needed custom manual shift boot. Going to be cutting down about 1" or more soon!!
Engine Bay Pictures:
Those engine covers now are almost done and look like this....
Last edited by Nachos23; 01-23-2011 at
09:42 PM
..
Appreciate
0
Quote
Nachos23
View Public Profile
Find More Posts by Nachos23