FS: Valve Cover + Vent Hose, Tensioner + Idler Pulley

[xwilkinx]

Recently did a lot of preventative maintenance on my F80 and replaced a lot of otherwise good condition parts.

Valve Cover (Part #11127846359)
Integrated PCV was 100% fine when removed. Decided to replace the whole valve cover instead of just the gasket.
$200

PCV Vent Hose (Part #11127850244)
Connects to the valve cover. No cracks, in good condition!
$40

Belt Tensioner (Part #11288088632) and Idler Pulley (Part #11288673720)
I replaced the belts and decided to replace the tensioner and pulleys at the same time.
$100 for both

Located in Ajax

[GreyblackM4]

Out of curiosity, how were you able to take that PCV breather hose off without breaking the tabs on it? Did you have to use a special tool?

[xwilkinx]

Originally Posted by GreyblackM4

Out of curiosity, how were you able to take that PCV breather hose off without breaking the tabs on it? Did you have to use a special tool?

I didn’t use any special tool! However I removed it from the bottom first (has a torx bolt) and then unclipped it from the valve cover. I did this while it was still warm to the touch so I figure the plastic was less brittle.