Anyone have the AWRON gauge?

[WillMotivation]

Originally Posted by tom @ eas

Awron is not compatible with JB4, sorry.

Ok thanks for quick reply. Can I just disconnect it or do I have to revert all of the wiring changes?

[tom @ eas]

Originally Posted by Turrizt

Ok thanks for quick reply. Can I just disconnect it or do I have to revert all of the wiring changes?

I should clarify, as long as you are in Stage 1 mode (no CAN wires on JB4 attached) the Awron display will function properly. Otherwise, the JB4 locks up CAN.

[WillMotivation]

Originally Posted by tom @ eas

I should clarify, as long as you are in Stage 1 mode (no CAN wires on JB4 attached) the Awron display will function properly. Otherwise, the JB4 locks up CAN.

I had a shop hook up stage 2. Wondering if I disconnect the gauge will JB4 work properly or do I have to revert all of the wiring.
Thanks Tom

[tom @ eas]

Originally Posted by Turrizt

I had a shop hook up stage 2. Wondering if I disconnect the gauge will JB4 work properly or do I have to revert all of the wiring.
Thanks Tom

Both devices cannot be connected to CAN at the same time, you'll need to remove one or the other.

ESS T-500 Flash tune and Awron work perfectly together.

[Jacky Jing]

Originally Posted by tom @ eas

The current Awron firmware was made to be fully compatible with JB4, we've tested this extensively on our dyno. There is also a passive mode option in the config menu for datalogging.

Hi,I have one question, after I installed the display screen and it flashes while driving. The message "service mode" Blinks. What should I do? Is that display problem or something wrong? Thank you