BMW stage 1

[8600RPM]

I just did it for service. Took 15 mind to remove obd2, tmap and map sensors and remove box. Too 15 mins to reinstall

[idocm4]

Originally Posted by 8600RPM

I just did it for service. Took 15 mind to remove obd2, tmap and map sensors and remove box. Too 15 mins to reinstall

Did you have to go through the adaptation process again after you reinstalled the tune? I assume the ECU needs to adapt again to the change in boost pressure.

[Mike@N54Tuning.com]

Originally Posted by idocm4

Did you have to go through the adaptation process again after you reinstalled the tune? I assume the ECU needs to adapt again to the change in boost pressure.

You just need to drive for a few minutes around.. Nothing special really.

Mike

[08cyber]

I'm going to guess its recommended to install the JB4 post 1200 mile "break-in" period?

[Mike@N54Tuning.com]

Originally Posted by 08cyber

I'm going to guess its recommended to install the JB4 post 1200 mile "break-in" period?

Thats what is usually done..

Mike

[JTO24]

Originally Posted by Mike@N54Tuning.com

Thats what is usually done..

Mike

Mike, a little off topic, but any word on when Terry will start shipping the JB4 units with the Molex connectors for the OBDII connection? PM me if this will derail the thread.

OP, great selection! The stage 1 is great; a gateway drug tho so be careful

[8600RPM]

The current t connectors wotk just fine. A little rough looking but they work well and it's not a 0rob

[babyboss]

Originally Posted by JTO24

Mike, a little off topic, but any word on when Terry will start shipping the JB4 units with the Molex connectors for the OBDII connection? PM me if this will derail the thread.

What is Molex connectors" "?

[Mike@N54Tuning.com]

Originally Posted by JTO24

Mike, a little off topic, but any word on when Terry will start shipping the JB4 units with the Molex connectors for the OBDII connection? PM me if this will derail the thread.

OP, great selection! The stage 1 is great; a gateway drug tho so be careful

Its planned in the near future..

Mike

[f10Bimmer238]

Originally Posted by Mike@N54Tuning.com

Its planned in the near future..

Mike

Mike I have the stage 1, anyway I can get on the computer and add boost to stage 1 in each gear so I can get a little more power out of this mod, like configure it 😁

[Mike@N54Tuning.com]

Originally Posted by f10Bimmer238

Mike I have the stage 1, anyway I can get on the computer and add boost to stage 1 in each gear so I can get a little more power out of this mod, like configure it 😁

Thats only available with the JB4 so you would need to upgrade to that.

Mike

[Mike@N54Tuning.com]

Originally Posted by babyboss

What is Molex connectors" "?

They are a form of wire connections.