04-30-2024, 09:33 PM | #1 |
Registered
0
Rep 3
Posts |
Accelerating Sensor
I was installing lowering springs a couple days back on a 2015 F80/M3. When I got the rear driver side , I unclipped the accelerator sensor (yes I know I didn’t have to do that) which came off fairly easily. When I went back to clip this sensor after the the spring install it didn’t want to fully go back in. I made sure there wasn’t any debris or anything in the senor blocking it from going fully back in. The sensor and the three connectors are all in place.
Is there a step I’m missing? I tried pushing it in with all my force and I feel like it shouldn’t be that hard to get this to clip back in… has anyone else had this issue? Any suggestions |
05-01-2024, 05:11 AM | #3 |
Major General
2461
Rep 5,918
Posts |
Do you have compressed air? If you do, try hitting both sides with a quick shot of compressed air to clean out any dirt and debris.
When you disconnected the connector was it a simple straight down pull to release it? |
Appreciate
0
|
05-01-2024, 12:39 PM | #4 |
Registered
0
Rep 3
Posts |
No I don’t but I’m going to borrow a buddy’s. And no I had to wiggle from side to side and apply some force (nothing crazy)
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|