01-09-2015, 01:52 PM | #67 |
Lieutenant Colonel
346
Rep 1,656
Posts |
IC. Is it possible to get a close up shot of the actual 3D symmetrical and multi-directional weave?
|
Appreciate
0
|
01-09-2015, 01:53 PM | #68 |
1764
Rep 7,650
Posts |
We will have product photos up shortly.
__________________
|
Appreciate
0
|
01-15-2015, 10:00 AM | #69 |
BimmerPost Supporting Vendor
2866
Rep 11,374
Posts |
F80 M3 3D trunk spoiler photos from TAS
New shots of the 3D Design F80 M3 trunk spoiler
3D Design RHD carbon mirror caps
__________________
|
Appreciate
0
|
01-16-2015, 11:48 AM | #74 | |
BimmerPost Supporting Vendor
2866
Rep 11,374
Posts |
Quote:
Here is a link- http://www.bulletproofautomotive.com/car/bmw/m4.html
__________________
|
|
Appreciate
0
|
01-16-2015, 12:16 PM | #75 | |
1764
Rep 7,650
Posts |
Quote:
3D decided on using pre-preg autoclave manufacturing because the end result is simply of a higher quality than vacuum-infusion. Through the introduction of a much higher pressure on the product, an autoclave will create more precise and crisper lines than vacuum-infusion. Also, combining pre-preg material with this production method will yield consistent weave and a very strong end product. Pre-preg allows the manufacturer to get the exact ratio of material to resin. Hopefully that answers some questions, but if any should arise feel free to contact us directly. We are always happy to field questions via PM, email, or phone. Andrew
__________________
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|