|
Post Reply |
|
Thread Tools | Search this Thread |
02-28-2021, 02:21 PM | #23 |
I Drag Race My Track Car
200
Rep 226
Posts |
Those of you using jb4 or a progressive controller. What settings are you using for your START FLOW psi and FULL FLOW psi?
__________________
ProSpoolFreaks Tuning E85
CBC Squad |
Appreciate
0
|
05-06-2022, 05:37 PM | #24 |
Captain
617
Rep 600
Posts |
Where can I buy the blue pales of race grade methanol?
My meth setup was just installed. Also went with Snow Performance (braided lines option) + two #5 nozzles placed on the cold side of EOS Charge Cooler and also using the Burger-tuning 3-gallon reservoir tank. My VC-50 controller is currently just sitting in the driver side storage compartment and I'm just waiting for the 52mm air vent gauge pod to come from Taiwan. I ordered 2 of them just in case the plastic is brittle or I break one by accident during the gauge install. Car is currently under the knife for w/EU5 injectors, Bend Calibration Ultimate Flex Fuel and PnP CANbus wiring harness so I haven't drove the car yet.
__________________
Last edited by tomlong; 05-06-2022 at 06:39 PM.. Reason: Grammatical errors |
Appreciate
0
|
05-06-2022, 10:13 PM | #25 |
Brigadier General
2896
Rep 3,726
Posts |
Is it possible just to use distilled water with these systems without meth?
I like the idea of cooling charge air similar to the GTS but I've always been hesitant to run meth+water.
__________________
2017 F80 M3 ZCP / AA GESI DPs / Akrapovic Evo / BBS FI-R 19" / Bend Calibration ECUTEK Flex Fuel | Bilstein B16 DDC + CS EDC / BMC Filters / BMS OCC / CSF HE / ESS CP / Nitto NT555R2 / PD Crank Hub / SPL Suspension / Uniden R7 / Wagner Top Mount IC
2021 Mini GP3 / BMC Filters / BM3 / Cary Jordan E30 / Wagner IC / Remus Race |
Appreciate
0
|
01-16-2024, 08:09 PM | #26 |
Lieutenant
399
Rep 530
Posts |
reviving an old thread. with the snow vc50 controller where are you installing the provided map / boost sensor for the controller? or how are you hooking it up? I am going to spray water into the j pipe so was thinking of pulling from the charge pipe. I also have the boost tap for the map sensor on the tmic but would have to run a vaccum line and then tie in the sensor. Appreciate some feedback on how others have done it.
|
Appreciate
0
|
03-26-2024, 08:04 PM | #27 | |
New Member
0
Rep 17
Posts |
Quote:
Retweet Me to think how to put the VC-5 boost pressure waiting for any answer |
|
Appreciate
0
|
03-26-2024, 11:28 PM | #28 |
Lieutenant
399
Rep 530
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|