01-10-2017, 11:07 AM | #1 |
Enlisted Member
4
Rep 30
Posts |
Anyone had fitment problem with Kohlenstoff diffuser?
Bought one on this forum from other folk. I got it yesterday and brought it to my local bodyshop ASAP. They told me the fitment is not good. The right side is fine, the hole is on the right place so they can put screw in it, but the edges are not parallel. The left is opposite, the edges are parallel, however the holes are not on the right places. I contact the seller and he told me the fitment is perfect on his m3. Im kinda confused...is this because mine is a m4? Or the fitment is just bad? I wonder anyone has same problem?
|
01-10-2017, 02:37 PM | #2 |
Mlightened
1852
Rep 2,242
Posts |
On my M3 it fits perfect. The only issue was I needed double sided tape on the part dehind the wheel to remove the gap.
My buddy had it on his M4, don't think this is specific to a model. |
Appreciate
0
|
01-12-2017, 08:19 PM | #5 |
Enlisted Member
4
Rep 30
Posts |
|
Appreciate
0
|
01-13-2017, 01:16 PM | #6 |
Lieutenant Colonel
1538
Rep 1,665
Posts |
I don't think the F80 M3 and F82 M4 has the same rear bumper covers. While the rear diffuser section is identical and diffusers and exhausts can generally be exchanged between M3 and M4, for the diffusers that extend out to the right and left sides of the rear bumper, there could be differences. Remember that M3 rear bumper has a flare out to blend in with the flared rear wheel wells whereas m4 rear bumper does not flare out but has more of a coke bottle widening to match the M4 rear wheel well:
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|