Quote:
Originally Posted by Greg FEightytwo
Here is the info on the CAN connection I shared before:
we still don't have any experience with BMW 3 and 4 Series (F30/F80 F32/F82) but in addition to the FlexRay, there are still three different CAN lines (K-CAN, PT-CAN and PT2-CAN).
In my opinion the existing BMW - F_21 driver should also be compatible with these models, in particular with the PT CAN.
The Powertrain CAN wires are still Blue/Red CAN-H and Red CAN-L, in alternative they can be CAN-H Black, CAN-L Yellow.
This bus is accessible on the Gateway (ZGS-FEM), on the ECU (DME), on the instrument cluster (KOMBI) and several other units.
As discussed above, the PT-CAN is what you are looking for and it should be:
CAN High: Blue/Red
CAN Low: Red
I think there is a cable that hooks up to solo dl and has exposed wires for can connection that we can order. I'm waiting to hear back from the rep.
|
You can take CAN off the FEM_BODY module using the Awron instructions here:
http://f80.bimmerpost.com/forums/sho....php?t=1017936. This is located behind the passenger side kickpanel.
CAN lines are PINS 47/48 on connector 8.
Power/Ground are PIN 20/24 of connector 3:
Simply tap into these lines and use F21 profile for setup. Hope this helps.