Quote:
Originally Posted by rcharles30
Quote:
Originally Posted by jimbob123
There not too bad to do, I've just done mine. Just got to be careful to seat the new gasket in the valve cover firmly, it's very flimsy so you don't want it to drop down on reassembly. Have a cloth wrapped round the fuel pipes when undoing the unions to catch excess fuel. You don't have to disconnect the intercooler completely you can leave the coolant pipes on and just lift it to one side.
Hope this helps, good luck.
|
Thanks for the info. Did you use any of the RV gasket maker on the sealing surfaces. Didn’t see a mention of it in the instructions but have seen a couple of how-to’s that said put a bead on the 4 corners and put a bead on the front, rear and passenger side surfaces before assembly. |
Didn't use any sealant on mine and it's been fine so far.