Quote:
Originally Posted by ECO-LAP
Before applying epoxy resin, I remove the air bubble by dipping the mixing cup in hot water when mixing epoxy resin and hardener.
When applying epoxy resin, apply it as thinly as possible.
This process minimizes air bubbles
|
Quote:
Originally Posted by nearwater4me
I’m assuming you’re based in S. Korea judging by the emoticon you’re using (^^ lol)
Nice work!
Did you have any trouble with air bubbles/voids in the resin coating? If so, how did you remedy the issue?
I have seen some surface imperfections when working with fiberglass and wanted to know how to avoid those.
TIA
|
OP demonstrates this in one of this other videos. mix epoxy in cup, submerge cup in warm (near boiling water).
start at 4:35.
if you have a mini torch, you can use the heat from that to remove any air bubbles as well after applying the layer of epoxy
start at 5:18