Quote:
Originally Posted by Jonjt
I'm about to get on a call, I cannot start doing the math until I get home.
Just answer this one simple question, did you or did you not use the posted engine power and torque curves, without numbers, to calculate the estimated shift points?
I can just pull the data from anywhere but, without the same data between the two of us, this comparison is meaningless. You should know this.
|
I believe that he wrote previously that there was no power and torque curves (dyno chart) available, and that he just used the factory stated hp and torque numbers as per my link in a previous post.
Not sure if that was what you were asking though...