Quote:
Originally Posted by allinon72
Looks good but I'm confused as to how the "center holes don't line up" as those are drilled during the installation process? The center support plate will determine that alignment.
|
The predrilled holes on the center of the lip did not line up with the plate. For example, once you mount the plate behind the lower bumper, the threaded inserts did not line up. Also, all four side holes were too short to match the original holes in the bumper. This was with the lip pushed back completely flush. So I had to drill new holes on the under sides of the bumper slightly forward and re-drill the splash guard so that they can all fasten. I must have mounted this thing about 5 times before pulling the tape adhesive and finishing. That’s how off the holes were.