I have the same issue with the front left Perch
it sits 10mm higher than right side, I also spoke to tech and he reckons it's press fitted on.
even than, if it was no pressed on well enough with the weight of the spring and car it would of forced the higher perch lower and that has not happened.
So i am also lost for words on this as well.
we will be stripping things again to double check as I also got a clunking noise over small sharp bumps.
Full coil overs FTW, If I had to do it all again I would go with Ohlins or JRZ.
Last edited by whoop_ass; 06-14-2018 at 11:46 PM..
|