Quote:
Originally Posted by Justin.AutoTalent
The inner fender liner is basically a big half circle if you think about it.
There are certain points/height of the wheel where the tire or even wheel and tire will touch based on your height and suspension.
The set up in this thread does not touch either point but he is also not slammed nor is he stock height.
If the height was closer to where you or I lowered it will for sure touch up in the standard spot that all wheels rub on when lowered too much. (The rounded portion of the inner fender)
|
My bicycle tire 295/30s don't touch anywhere running 11" width, ET40, and stock spec rear camber. I am nowhere near where your height's at, but certainly lower than this CS which is a bit on the high side, thus my inquiry to chase this down. Sounds like jury's still out?