So, here's the issue I ran into. This morning while fitting the wrapped shark fin, I saw that the one edge looked like it had water under it.
Realize, it's just a sticker...it does not have water, but no idea how this just came up. If you look at the driver side above that was taken yesterday - it's not there.
It looks like I may have 'over stretched' this area, and it is on an edge...but I really can't recall doing so. I'm not sure how to go about fixing...
For this reason alone, if I cannot resolve, I may switch to all black.
__________________
Proud owner of 4 Turbos and 1 Supercharger
|