Just a few tips:
1) The bumper doesn't go that far back, but once you pull it back a little, there is a rubber flap inside attached to the support that you can push out of the way
2) to push down on the tabs, do the top ones with a screw driver, easy to do and see once you do 1); to do the bottom and side ones, you need only your fingers, but make sure you push the grill in when pushing down on the tabs (gives it more slack and makes it much easier) and pull once pushed in
Note for IND, the Torx 27 works for the middle ones, but the outside Torx is a different number. I had to use a flat head to get them out since I didn't have the right bit. Please update.
__________________
2015 ///M4: M/Vorsteiner Aero, P3Cars, HRE R101, Dinan S2, Coils & Intake; Eis/Akra Exhaust
2013 WRX Hatchback: LED Conversion, Blacked Out, Rally Armor
2015 Macan Turbo: Techart Exhaust, Cargraphics Lowering Module, Blacked Out
Last edited by redfox; 07-11-2014 at 10:09 AM..
|