Quote:
Originally Posted by hellokitty
Does the bend ultimate BM3 kit have enough length to plug into the F80 FEM module or do you need to extend the harness in order to get the wire from under the car into the cabin?
|
From what I have read (and I don't have the kit yet) the harness will need to be extended. Although, allegedly this has been brought to the attention of Bend and supposedly they may provide a longer harness so you should ask them. Although, there is a PT-CAN bus tap point in the driver side footwell as well (I forget the module name off hand, found it in the wiring diagrams in ISTA). But I have not been able to find a good fire wall penetration on the driver side other than the clutch line - which does not work for me since I have a 6MT.