Bilstein B16D Damptronic coilover kit with ground control camber plates

[biofluke]

BIMMERPOST / Classifieds

Asking Price:

Sold

Or Best Offer

Item Interest

I have a set of Bilstein B16D Damptronic for sale. To sweeten the deal, I'll throw in some Ground Control Camber plates if the full asking price is paid

I was running this setup on my car for a while but became a track addict, so I decided to go with an MCS 3-way kit. When I removed the Bilstein from the car, I noticed one of the shocks was leaking. After RMAing the setup, they sent me 2 totally new shocks (because they apparently lost one). So half of this setup is new, never installed.

I took them off the car almost 2 years ago, but it took forever for Bilstein to RMA the shocks. The whole setup had around 8k miles on it.

Pickup in Westchester, NY. Willing to ship but it will cost a lot to insure because it's very heavy.

[bimmermansfl]

Are they adjustable? Sorry I don't know much about this kit. How was the stance?

[biofluke]

Originally Posted by bimmermansfl

Are they adjustable? Sorry I don't know much about this kit. How was the stance?

https://www.turnermotorsport.com/p-5...f-susp-system/

Yes, they are height-adjustable. Stance can go as low as you want it to. I actually had to raise it up a bit after driving it for a while because I was scraping my bumper too much.

They also tie into the EDC, so the Comfort/Sport/Sport-Plus settings will change the damping on the shocks. It's an excellent setup for a street car that might see an occasional track, autocross, or backroad. I just went to more of a dedicated track setup.

[Goettler_Boost]

Do you have any pics of how your stance was on the car?

Which struts are new? Any hardware missing? Pics look good so far.

[biofluke]

Originally Posted by Goettler_Boost

Do you have any pics of how your stance was on the car?

Which struts are new? Any hardware missing? Pics look good so far.

There was one new front and one new rear. I have a whole box of hardware my installer gave me, so I'll just give you everything. I do not think there is anything missing, but I'm not sure if I'd know either. If anything was missing, I don't think it would be bilstein-specific, and any competent installer should be able to handle it. There are also still 2 of my BMW EDC black boxes on the setup that normally don't come with it. I don't use the EDC anymore so I'll just leave them on there.

I did not have the car slammed all the way down and could have gone much lower, but I was just trying to eliminate the wheel gap. You could go much lower, or a little higher than this, if that's what you looking for.

[biofluke]

Dropping price to 1900. Need garage space for winter!

[Anarchy919]

How much for just the GC plates?