Anyone else get banned from the G8X section for making fun of its looks?

[mzcp]

Originally Posted by jmg

How are the Rsl29s in the street? I don't mind too much the low temp performance as I am used to track pads on the street, but I am concerned about noise. Are they noisy?

Have you tried the Endless MX-72 Plus or ME-20? I have the MX-72 Plus on my car now. Much better than my stock pads in the Canyons. They squeak a little. A friend recommended Cobalt pads but they are expensive.

[dmk08]

Originally Posted by Sedan_Clan

Sexy! Such great looking cars.

I would put them in the same category of good looking as a G80.

[jmg]

Originally Posted by mzcp

Have you tried the Endless MX-72 Plus or ME-20? I have the MX-72 Plus on my car now. Much better than my stock pads in the Canyons. They squeak a little. A friend recommended Cobalt pads but they are expensive.

I actually just ordered ME-20 this afternoon! Coming from Japan.

[mzcp]

Originally Posted by jmg

I actually just ordered ME-20 this afternoon! Coming from Japan.

Did you order thru Blackhawk Japan? They have the best prices. Wait time was two months for me.

[jmg]

Originally Posted by mzcp

Did you order thru Blackhawk Japan? They have the best prices. Wait time was two months for me.

Yup!

2 months?!?!?

Is that transit time only or were they not in stock? It’s like ordering a car.

[mzcp]

Originally Posted by jmg

Yup!

2 months?!?!?

Is that transit time only or were they not in stock? It’s like ordering a car.

Not in stock. They built after I ordered them. It could be that yours are in stock. Shipping is only a few days. Brake pads and lines for about $500 shipped so not bad

[jmg]

Originally Posted by mzcp

Not in stock. They built after I ordered them. It could be that yours are in stock. Shipping is only a few days. Brake pads and lines for about $500 shipped so not bad

I just got an email from them. Made to order. 1.5 months to make. I’ll be pushing the factory pads on track until then!

[Sedan_Clan]

One of my partners’ modded F82 is looking so menacing right now.

[clutchdj]

Originally Posted by jmg

How are the Rsl29s in the street? I don't mind too much the low temp performance as I am used to track pads on the street, but I am concerned about noise. Are they noisy?

yes they are pretty loud on the street after they're heat cycled. I tried to run them on the street for a few days after the glen last October, but there was just no sneaking around with them some pads just drag a lot, but the these were just loud. happy with them, just not a dual purpose pad.

[440i6MT]

Another /M car I have my eye on at the auction
kinda curios what Stage Dinan its equipped with. I think only Stage 1, given the lack of a strut brace.

Side-note: the prices salvage /M cars have been going for over the past few years or so have been ridiculous. It’s like night & day compared to pre-Covid. Odds are I won’t be getting close to this one, but I’ll see.