03-16-2019, 10:06 PM | #1 |
Mechanical Engineer
94
Rep 187
Posts |
Polished headlights, worried I removed UV layer
So I was ignorant and not aware there was a UV layer on headlights.
I used a DA orbital to polish the headlights with light swirl remover polish, what should I be doing next to damage control this?
__________________
"It is not that we have a short time to live, but that we waste a lot of it. Life is long enough, and a sufficiently generous amount has been given to us for the highest achievements if it were all well invested..."
|
03-16-2019, 10:27 PM | #2 |
Private First Class
74
Rep 145
Posts |
I drove through a sandstorm and my headlights suffered light needle-pin pricks, so I had them polished to remove the top damaged layer. I then had the headlights covered in Suntek Ultra film—that should provide similar protection to that original layer you buffed out.
|
Appreciate
0
|
03-16-2019, 10:35 PM | #3 |
Colonel
766
Rep 2,361
Posts |
If you're that worried about it, go to Xpel's website and buy pre-cut film for your headlights. I did that on my E90 M3 and the headlight lenses look like it just rolled off the factory
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|