FS: Ohlins R/T suspension kit

[adc]

BIMMERPOST / Classifieds

Asking Price:

Sold

Or Best Offer

Item Interest

Greetings folks, thank you for looking at my ad. For sale, my Ohlins R/T kit used for street and track the past 2.5 seasons. I estimate about 20k street miles and about 9-10 track events.

A few odds and ends have been refreshed (plastic or rubber isolator gaskets, top nuts etc). New stainless steel bolts and nuts for the accelerometers will be included, they're coming in this week. The kit will be shipped in the original box.

The suspension performs flawlessly, very capable on track and decent on the street. My best time at VIR with this setup and camber plates was 2:05, which is not bad for a fully street stickshift car. If needed, I can share setup advice and settings, to hit a sweet spot from the get-go.

Cosmetically there are a few flaws as seen in the pics. Before spacers, the tires made contact with the bottom of the front springs (an issue of aggressive fitment). A solid patch of melted rubber was deposited on the springs (black marks in the picture). Does not affect the functionality.

I have run these with both Ground Control and Vorschlag plates, with equal success.

My asking price is negotiable, and may or may not include shipping depending on the sale price. For ex at the asking price or close to it, shipping within CONUS is included.

If you have any questions, hit me up. I'm standing by.

[sm55]

what did you move up to? where in DC area- im in Columbia

[adc]

Originally Posted by sm55

what did you move up to? where in DC area- im in Columbia

Thank you for your interest. I installed the MCS 2WNR kit from BW.

I’m in Bethesda, but can meet up anywhere in the area.

[swcc50]

Can you ge the threads and stuff cleaned up? Would want to make sure it wouldn’t have any issues adjusting the settings.

And would you recommend a new set of bolts for install?

[adc]

Originally Posted by swcc50

Can you ge the threads and stuff cleaned up? Would want to make sure it wouldn’t have any issues adjusting the settings.

And would you recommend a new set of bolts for install?

I’ve checked the threads, the perch can go all the way up or down, and I will clean them again very thoroughly just be certain.

I don’t think replacing the bolts is necessary, especially if this is the first time you remove them. Mine have been on the car for 3 suspensions including OEM, since 2018. But if it provides reassurance to the buyer, I’m willing to include a set of new OEM front and rear shock bolts.

[adc]

Back up…