265/285 with spacers?

[yellowssm]

Originally Posted by Russell263

From what I have seen, my current front settings would be pretty close to Swift Springs, I think max front drop on the KW is 1.2" and I could still go about a .25" lower, and Swift Springs lower 1"

I would have had a real world answer on rubbing with the Re71r on swift for you, as I was supposed to have Swift Springs installed by end of day today, but the shop didn't get it done.

I'm pushing it with the 12mm in front, and think it will be very close with your little bit of extra width, might be worth it to run the 10mm.

cool thanks. Why are you going with swift springs? Funny thing is at first I was thinking KW HAS but wanted to run a wide front tire so I went swift. Do you have any pics straight on of your front fender and tire? Wanna see how it sits. Thanks!

[whitefrs]

anyone know if I will have any rubbing issues with 15mm front 20mm rear spacers
front 265 and rear 285

stock height

[whoop_ass]

Originally Posted by whitefrs

anyone know if I will have any rubbing issues with 15mm front 20mm rear spacers
front 265 and rear 285

stock height

not 100% sure on stock Height but you will def rub, I am running Mperfomace HAS kit lowered to BMW spec
had a 15mm on front and it would touch the inside of bumper at top.

I think it safe to say 10mm in front and prob 12mm at rear but 10/10 is safe.
BTW i was running Pilot 4s rubber.

why would you want to run such big spacers on stock height
it looks so odd!
unless you trying to go for this look.

[Jaymax85]

12/10 is what I run

[whoop_ass]

Originally Posted by HELLOimJ

12/10 is what I run

are you on Michelin PSS or 4s
the 4s are known to run a bit wider than the OEM PSS

good to know that there is no problem with 20" but I think a 265/35 19" is a smidgen taller than the 265/30 20"
I am going to install my spacer today and test again with 10/10 and than I will test with 12/10.

I will drop feedback back here once I have tested

[Jaymax85]

Originally Posted by whoop_ass

are you on Michelin PSS or 4s
the 4s are known to run a bit wider than the OEM PSS

good to know that there is no problem with 20" but I think a 265/35 19" is a smidgen taller than the 265/30 20"
I am going to install my spacer today and test again with 10/10 and than I will test with 12/10.

I will drop feedback back here once I have tested

Pss

[whoop_ass]

Originally Posted by HELLOimJ

Pss

makes sense as they run narrower the the 4S
265 PSS on the front rim still looks a bit stretched compared to the 4S it has a more Square profile.

[eXstasy]

Originally Posted by whoop_ass

are you on Michelin PSS or 4s
the 4s are known to run a bit wider than the OEM PSS

good to know that there is no problem with 20" but I think a 265/35 19" is a smidgen taller than the 265/30 20"
I am going to install my spacer today and test again with 10/10 and than I will test with 12/10.

I will drop feedback back here once I have tested

This was definitely my experience. PS4S 265/35/19 front and 285/35/19 rear. Taller tire, square shoulder. 12mm front spacers with 10mm rear spacers.

I am getting rubbing on some turns especially with suspension compression on my stock ride height, base M3. Unsure what my alignment specs are, I have to dig up the sheet, but it was last aligned by a BMW dealership, likely within stock specs.

Might try to swap the front and rear spacers to run 10/12, or just go down to 10 all around which was my original preference anyhow.

[M 4 FUN]

I run 12 front and 10mm rear. That is perfect if you want your tires to not stick out from the fenders and blast your sides with stones and debrees to much.

[NickyC]

Here’s my setup, took a lot of trial and error as I ripped off my first front lip. We initially had the front much lower, but with the height now I haven’t scraped a single time and she’s still LOW. There is absolutely no rubbing on front or rear, I think we’re at the limits of my current setup. While I’d like the front to be a smidgen lower, I think it still came out great and I get asked all the time if bagged. Specs below:

KW V3 coilovers.
10mm front with 5mm rear spacers.
PS4 265/30/19 front and 295/30/19 rear.
Stock 437m wheels.

[Rusticm3]

Originally Posted by NickyC

Here’s my setup, took a lot of trial and error as I ripped off my first front lip. We initially had the front much lower, but with the height now I haven’t scraped a single time and she’s still LOW. There is absolutely no rubbing on front or rear, I think we’re at the limits of my current setup. While I’d like the front to be a smidgen lower, I think it still came out great and I get asked all the time if bagged. Specs below:

KW V3 coilovers.
10mm front with 5mm rear spacers.
PS4 265/30/19 front and 295/30/19 rear.
Stock 437m wheels.

Hi, do you notice any increase in understeer with this setup and does your TC behave ok?

P.S. Sorry to revive an old thread im so on the shelf about what tyres to upsize too.

[Rusticm3]

Originally Posted by AM4ZING

Stock wheels with 10mm rear and
12mm front

Vorsteiner wheels with 5mm front and 3mm rear

Hi, do you have any more pictures with the stock wheels? Been through your threads and can't find anything

[jaylazy2020]

Originally Posted by Rusticm3

Hi, do you have any more pictures with the stock wheels? Been through your threads and can't find anything

That’s my 2018 F82 on 10mm front and 12mm rear on stock 666 with PS4s

And then the 763m with PSS

666 are 265 front 285 rear

763 m are 255 front and 285 rear

[Rusticm3]

What pressures are everyone running on the 265/35 285/35 setup? Are there any more people running this who can post more pictures?

[agentrnge]

Will have mine mounted tomorrow. Will post some. I am 100% stock, not lowered, on 437s.