01-04-2023, 12:13 PM | #5 |
Enlisted Member
7
Rep 44
Posts |
I have the full dct service kit from FCP euro with the pan, filter, bolts and pentosin fluid. I can sell it to you for cheap and you can get the service done on your own. I sold my car before I got to do it
|
Appreciate
0
|
01-11-2023, 11:15 AM | #6 |
Private
10
Rep 56
Posts |
Gdo and jkings auto is a good shop for this. I personally went to jkings but a lot of my friends go to gdo and I heard nothing but good things from them.
|
Appreciate
1
TheM3Chase41.50 |
01-16-2023, 07:20 PM | #7 |
Private
42
Rep 68
Posts |
+1 for King's Automotive in Bloomingdale!!
|
Appreciate
1
.Tranceparent.127.00 |
01-18-2023, 09:53 PM | #8 |
Private First Class
43
Rep 178
Posts |
A bit late to this but Autocouture in NJ, Motorcepts in Queens, Stance shop in Queens,
|
Appreciate
1
Matt@AUTOcouture4166.00 |
01-19-2023, 03:36 PM | #10 |
Brigadier General
5393
Rep 3,737
Posts
Drives: 2016 M4 DCT Tanzanite/Amaro
Join Date: Oct 2016
Location: Princeton
|
attached below is a forum member’s DCT Blackstone report, analysis performed 11/2020 on a 2015 F8X (OEM tune) with 77.6K miles. note the included comments.
based on this report among others I will service my own F82 DCT at 65-68K miles (I’m no where near that). seems like overdoing it but considering I will do this at most twice during my ownership I call it cheap insurance. that doing so (and having a Blackstone to prove it) is likely to enhance resale value is just a bonus, imo. caveat: as always longevity and mileage estimates are subject to how the car is driven and maintained but given a well cared for F8X and a non-lunatic driver, these numbers are reasonable. also, bare in mind that this is not the same DCT used in F9X and a few others. it is THE SAME gearbag found in M5 and M6 before they went torque-converter. it is VERY robust. |
02-22-2023, 07:28 PM | #12 |
New Member
0
Rep 13
Posts |
|
Appreciate
0
|
02-23-2023, 07:46 AM | #15 | |
BimmerPost Supporting Vendor
4166
Rep 2,319
Posts |
Quote:
It would be best to have that redone. The DCT's need to be brought up to a specific temperature and then pumped out of the of the trans via ISTA's refill procedure. Lots of areas the old fluid will not come out of with a standard drain and fill. If you refilled it to factory specs, you may have overfilled if not enough came out. |
|
Appreciate
1
Poiseuille5392.50 |
03-09-2023, 11:51 PM | #16 | |
New Member
10
Rep 28
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|