11-30-2021, 06:34 AM | #1 |
Second Lieutenant
68
Rep 288
Posts |
ISTA D Help!
Hoping someone can guide me through some issues I've been having installing and running Ista D on my car.
I installed Ista D last week, but as soon as I start the program I receive an error message " a fault occurred the last time Ista d was installed which leads to data inconsistencies. To rectify, open Ista launcher and carry out repair installation." Unfortunately when I look in the tools folder I don't see any type of repair to run. I also don't see anything in the Rheingold folder. The second issue, when I connect the cable to the obd port in my car, I am receiving another error message, " the vehicle could not be identified successfully, check vehicle interface and pad active". For this reason I can't run a diagnostic on the car. My cars Vin does pop up, but then I get that error message when I try to complete the vehicle check. I am using an old Sony laptop with a windows 7 operating system that I use solely for the car. Also the obd cable connects to the computer via Ethernet and not usb. Any help or advice would be appreciated. I have spent hours trying to figure this out but I'm at a dead end. |
12-08-2021, 07:14 AM | #4 |
BimmerPost Supporting Vendor
1792
Rep 3,057
Posts |
Your ISTA installation is bad. You need to source good one
__________________
Apple CarPlay Fullscreen for NBTEVO / ENTRYNAV2 / Anti-Dazzle F/G
CS FLASH G8X /GTS FLASH F8X / F8X Ultimate PACK / NBTEVO iDrive 6 FLASH iDrive Firmware Update + CarPlay Fullscreen -> Video Process Visit BIMMER-REMOTE.com - 10% OFF with BIMMERPOST_10 promocode info@bimmer-remote.com or PM |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|