10-04-2021, 02:30 PM | #1 |
Captain
528
Rep 855
Posts |
Torque spec for reinforcement plate
Hi guys,
Can someone tel me the torque specs for the Bolts for the aluminum reinforcement plate mounted below the engine? Thanks Steve |
10-04-2021, 04:19 PM | #2 | |
Lieutenant
964
Rep 552
Posts
Drives: 2018 M4 ZCP 6MT
Join Date: Apr 2018
Location: Virginia
|
Quote:
https://f80.bimmerpost.com/forums/sh...38;postcount=2 Actual torque specs: approximately 2.5 ugga-duggas
__________________
2018 F82 ZCP 6MT: FBO, Kratos KRAS55Bi, EU5 Injectors, Dorch HPFP Lift Kit, Stage 3 LPFP, Bend Calibration Zeitronix ECA-2, BM3 Flex-Fuel Tune by ABP
For Sale |
|
Appreciate
0
|
10-14-2021, 08:00 AM | #4 | |
Enlisted Member
14
Rep 31
Posts |
Factory torque spec
Quote:
If using a used bolt, then limit torque to 55ft-lbs (from calculation based on bolt size and grade). I use anti-seize on the thread and a small dab between head and washer. |
|
Appreciate
1
Kilabyte3948.00 |
10-19-2021, 04:08 AM | #5 |
Brigadier General
1836
Rep 4,203
Posts |
Most torque values are "dry" values. Personally I re-use all the bolts and torque to value spec. I do not + deg the used bolts. Also on bolts that rarely get removed or high stress areas I applied a small dab of Loctite 242
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|