03-10-2021, 02:15 AM | #23 | |
Private First Class
52
Rep 107
Posts |
Quote:
Is this BOV going to protect my hybrid turbo's? When I am boosting and come off the throttle, I do hear intake sounds which I assume is trapped pre-throttle boost reversing through the turbo and out of the intakes. |
|
Appreciate
0
|
03-10-2021, 09:46 AM | #24 |
Lieutenant Colonel
1582
Rep 1,976
Posts |
|
Appreciate
0
|
03-11-2021, 10:11 AM | #25 | |
Private First Class
36
Rep 129
Posts |
Quote:
__________________
Instagram: erik_m3g80
|
|
Appreciate
0
|
03-11-2021, 10:54 AM | #26 | ||
ECUTek Master Tuner
10438
Rep 1,728
Posts
Drives: F80 M3 YMB
Join Date: Jul 2017
Location: Colorado Springs
|
Quote:
2) it doesn't interfere with the turbo wastegates, the BOV is triggered by accelerator pedal position reduction. If you are getting surge when letting off the throttle or even slightly lifting the throttle, then yes the BOV should help, it did in my case.
__________________
Quote:
|
||
Appreciate
3
|
03-12-2021, 04:18 AM | #27 |
First Lieutenant
271
Rep 326
Posts |
|
03-12-2021, 10:56 AM | #28 | ||
Major General
5450
Rep 5,143
Posts |
Quote:
Since I drive stick and need to come off pedal during shifts how can the BOV be configured to hold pressure for shifts but release when needed? When I do my built motor this summer the BOV may be appropriate. Any other good electronic controls for this solution, like a Motiv or maybe the new BM3 chip? I'm learning to have as few controller boxes as possible, and more intelligence where possible.
__________________
'18 F80 Base 6MT | '19 F82 Exec DCT | '18 F82 Comp Exec DCT | '23 G80cx
|
||
Appreciate
0
|
03-12-2021, 01:12 PM | #29 | ||
ECUTek Master Tuner
10438
Rep 1,728
Posts
Drives: F80 M3 YMB
Join Date: Jul 2017
Location: Colorado Springs
|
Quote:
The electronic BOV controller that should be included with the kit can be adjusted to activate the BOV upon small APP reductions, or not open the BOV until large APP reductions. It was easy to fine tune it to my preference. I do not recommend using the intake manifold as the pressure source, I recommend using the Macht Schnell TMAP adapter on the intercooler for the pressure source.
__________________
Quote:
|
||
03-13-2021, 12:56 PM | #30 |
Captain
756
Rep 946
Posts |
^^Chetrickerman are you single turbo?
__________________
M4CS Frozen Blue
ARM DP's/Resonated Mid-pipe | SPL links | Hotchkis bars | JRZ RS2/camber plates | K&N | Koyorad HX | Powerflex purple | Rouge | Spiegler | Speed Eng. snorkel | Vargas CBC/hub | Wagner IC | xHP | Xpel stealth ppf |
Appreciate
0
|
03-13-2021, 07:12 PM | #31 | |
ECUTek Master Tuner
10438
Rep 1,728
Posts
Drives: F80 M3 YMB
Join Date: Jul 2017
Location: Colorado Springs
|
I am pretty much finished building my custom single turbo setup. But when I was running the BOV, I had Kratos turbos installed
__________________
Quote:
|
|
Appreciate
1
Wanted_M756.00 |
03-13-2021, 07:49 PM | #32 |
Colonel
1873
Rep 2,395
Posts |
Did this kit create a rich condition via DME when the air is actually blowing off, and/or do the benifits of reduced compressor stall (stock setups) out-weigh that??
|
Appreciate
0
|
03-14-2021, 02:20 PM | #33 |
Second Lieutenant
114
Rep 201
Posts |
Have someone buy it for you then have them Mail it to you.
__________________
2018 F80 Comp LSB | M4 GTS Exhaust | Eventuri Intake & CPs | Garrett TMIC | SSR CH | BM3 Stage 1 | ARM DP
|
Appreciate
1
behindthen0thing839.50 |
03-29-2021, 07:36 PM | #37 | |
ECUTek Master Tuner
10438
Rep 1,728
Posts
Drives: F80 M3 YMB
Join Date: Jul 2017
Location: Colorado Springs
|
No it does not because the DME is closing the throttle when you let off, so only a little bit of the air is actually flowing through the engine.
__________________
Quote:
|
|
04-13-2021, 05:33 PM | #39 |
Second Lieutenant
114
Rep 201
Posts |
No I haven't. They said end of March but something is holding them up.
__________________
2018 F80 Comp LSB | M4 GTS Exhaust | Eventuri Intake & CPs | Garrett TMIC | SSR CH | BM3 Stage 1 | ARM DP
|
Appreciate
0
|
04-13-2021, 08:03 PM | #40 |
Lieutenant General
17439
Rep 10,645
Posts
Drives: M4 CS. Former G82, x2 F82, F80
Join Date: Nov 2010
Location: Jacked out of my mind
|
This is truly a great day. I’ve been a BOV (the louder the better) hustler for years. Now all we need are big FMICs we could put on our cars!!
I love the whooosh piisssssh noises from BOVs hah!! I will say however, the noise in that video is pretty lousy. I want something obnoxious like the HKS SSBOV from back in the day. Hearing that video does not make me want this particular kit. |
Appreciate
1
Redacre367.50 |
04-14-2021, 01:04 PM | #41 |
First Lieutenant
140
Rep 335
Posts |
I was told next week they will stat shipping
But honestly they have been saying "next week" for over a month now |
Appreciate
1
garrettjusmc114.00 |
04-20-2021, 09:48 PM | #43 |
Legend
97
Rep 166
Posts |
I was told shipping this week. Fingers crossed.
__________________
Insta: @TexasF80 | YouTube:lvnvevo
Supported by: Limitless Car Care | Braum Racing | Opt7 | MRR Wheels |
Appreciate
0
|
04-21-2021, 11:36 AM | #44 |
Second Lieutenant
114
Rep 201
Posts |
I just got a tracking number for mine.
__________________
2018 F80 Comp LSB | M4 GTS Exhaust | Eventuri Intake & CPs | Garrett TMIC | SSR CH | BM3 Stage 1 | ARM DP
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|