11-17-2018, 11:58 AM | #1 |
Captain
390
Rep 659
Posts |
Emission light?
Hello
This morning when I start the car, emission light came on. The manual book said I need to have the system checked immediately. I installed the downpipe recently and is this something installer didn't do correctly? any help will be appreciated. |
11-17-2018, 01:03 PM | #2 |
BimmerPost Supporting Vendor
8215
Rep 18,823
Posts
Drives: BMW
Join Date: Nov 2005
Location: Anaheim, CA
|
Likely a code from removing primary cats, but you will need to run codes to verify.
__________________
Tom G. | european auto source (eas)
email: tom@europeanautosource.com · web: https://europeanautosource.com· tel 866.669.0705 · ca: 714.369.8524 x22 GET DAILY UPDATES ON OUR BLOG · FACEBOOK · YOUTUBE · FLICKR · INSTAGRAM |
Appreciate
1
M3nmotion18390.00 |
11-17-2018, 01:47 PM | #3 |
Private
82
Rep 96
Posts |
Do you have a tune to remove the MIL light? If not is because of the primary cat being removed, Its normal.
|
Appreciate
1
M3nmotion18390.00 |
11-17-2018, 02:31 PM | #4 |
Captain
390
Rep 659
Posts |
I don't have any tune. As Tom recommended and Mike, I'll have to find a shop to run the codes to verify. I should be fine driving the car then?
Thanks everyone!! |
Appreciate
0
|
11-17-2018, 03:00 PM | #5 | |
Private
82
Rep 96
Posts |
Quote:
Yes run the codes just in case, the car is going to be perfectly alright and it's going to run fine. Im a BMW tech my self and I can tell you is because of the primary cats being removed. Good luck fam 🙏🏼 |
|
Appreciate
0
|
11-17-2018, 03:25 PM | #6 |
Captain
345
Rep 966
Posts |
You need software for the CEL issue since you removed the cats
There are a lot of great software options available based on what your goals for the car will be. |
Appreciate
0
|
11-17-2018, 06:37 PM | #7 | |
Captain
390
Rep 659
Posts |
Quote:
On the way home, I stopped by the shop near my home (lucky they were still open late on Saturday) and asked them to see if they can run the codes and yes, it showed Catalytic Converter Efficiency below threshold and he cleared this code and CEL disappeared. The software he used was SOLUS EDGE! Thank you so much!! Last edited by M3nmotion18; 11-17-2018 at 06:43 PM.. |
|
Appreciate
0
|
11-17-2018, 07:34 PM | #8 | ||
Major General
4998
Rep 6,863
Posts |
Quote:
|
||
Appreciate
1
M3nmotion18390.00 |
11-17-2018, 09:58 PM | #9 | |
Captain
390
Rep 659
Posts |
Quote:
I'll make sure to do this if CEL appears again before I do the 1200 mile service. I'm planning to get the Bootmod3 for tuning....this will resolve a problem then? Thanks for the information!! |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|