10-12-2021, 10:29 PM | #1 |
Second Lieutenant
92
Rep 299
Posts |
Cutting OEM cat back for transport/storage
I recently purchased the Akrapovic slip-on +VRSF mid pipe from another forum member. Looking to get it installed this Friday. I need to be able to transport my OEM exhaust back home in my car. What should I tell the shop where to cut that would make the most sense? Or does it even matter?
I would think if any cuts are to be made, it should be anywhere that's straight. |
10-13-2021, 06:56 AM | #2 |
Colonel
2889
Rep 2,147
Posts |
The most sensible location is where the VRSF mid pipe tells you to cut the stock muffler to mate it. That way if you ever sell the muffler or mid pipe it's in a location that people are expecting to bolt up to theirs. You can get a worthwhile amount of money for both.
It makes transport a little challenging done this way, but if you cut anywhere else, you'll need to fit it to your car and weld it back on if you ever sell the midpipe in the future. I suppose you could buy clamps but that's hacky. Can always cut it twice to make the midpipe shorter. Just bring lots of towels to rest the stock pipes on, don't want to wreck that interior.
__________________
YT: ntg44
|
Appreciate
0
|
10-13-2021, 07:36 PM | #3 | |
Second Lieutenant
92
Rep 299
Posts |
Cutting OEM cat back for transport/storage
Quote:
Also curious why you would consider using clamps as hacky. Isn't that what's typically used for these kinds of aftermarket midpipes with the stock rears to mate it up? Last edited by dawei213; 10-13-2021 at 10:37 PM.. |
|
Appreciate
0
|
10-13-2021, 08:11 PM | #4 |
Private First Class
68
Rep 149
Posts
Drives: BMW M3
Join Date: Feb 2020
Location: Bay Area
|
I have a stock exhaust in my garage and just measured the exhaust where it would be cut at before the muffler, the mid pipe would be around 103", the muffler is about 36"x30" when cut off the mid pipe, it looks like it would fit if you were to fold back the passenger seat and put it at an angle on top of the passenger seat left of head rest and kinda strap it so it doesn't move and place some blankets down, it might work straight trough where the shifter/gear selector is but it would block it but it looks really tight. Double check if it would work for you.
|
Appreciate
1
dawei21391.50 |
10-13-2021, 08:37 PM | #5 |
Private First Class
122
Rep 171
Posts |
I'm going through the mid pipe jigsaw right now too. From the rear edge of the trunk compartment, it (mid pipe cut to length for the AA single replacement) will extend the whole way up to the gearshift (in an M3). Wrap in towels and duct tape and use a ratchet strap to loop around and secure to the trunk anchor points. Not ideal for any duration of a drive.
|
Appreciate
1
dawei21391.50 |
10-13-2021, 10:39 PM | #6 |
Second Lieutenant
92
Rep 299
Posts |
Appreciate the feedback fellas.
Tdog86, thanks for taking the time to measuring it. That's what I'll probably end up doing in terms of laying it down in the car. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|