12-01-2021, 07:41 AM | #1 |
Registered
0
Rep 1
Posts |
UPDATE: Found a set screw missing in one of the charge pipes allowing for air to escape. Sounded nice, but probably losing power. Replaced with a set screw from Ace Hardware. I'm sad that they were so loose from the factory. The one that was still on was so loose I was able to loosen it with my hand. Anyways, problem fixed. Thanks!
Hey guys, I'm not a usual forum poster. I usually just look through things to find answers, but today that changes. I bought a new-to-me M3CS. Upon further investigation, I found out that the car had been modified and reverted to stock before I bought it. Previous owner had done the Crankhub, Spark Plugs, Downpipe, and Charge Pipes for physical modifications, and then a tune. None of this is pertinent to what I was going to say. I heard the horrors from the crankhub and the charge pipes so I decided to do the charge pipes, as I feel like the crankhub was probably never reverted to stock due to the difficulty. Whenever I work on my card I'm super meticulous, and make sure that I do everything by the book. I finished the install, but felt like the air box was allowing air to escape due to it not being a tight fit with the air inlet. Well I got some zip tie and tightened the air box to the inlet. Not really tightly, just to make sure that the air wasn't escaping. Driving today, I realized that under load, the induction sound is much louder. I had an Evo pushing 32 psi, and it's not as loud as the Evo was, but it still is louder than it was pre-aftermarket charge pipes. Is it normal to have that sound be much louder? Everywhere I've read it says that the charge pipes don't add performance or sound. Mechanically, I can't see how it would add performance or sound. TL;DR: is it possible at all, to get a louder induction sound with aftermarket charge pipes and no other modifications? |
12-01-2021, 08:53 AM | #2 |
BimmerPost Supporting Vendor
24059
Rep 190,575
Posts |
it is normal to hear more of the turbo sound when the upgraded charge pipe is larger than stock, but it can also be due to a boost leak.
The only way to check is to do a boost leak test .
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
12-06-2021, 03:21 AM | #4 | |
Second Lieutenant
137
Rep 257
Posts |
Quote:
I typically fabricate a hose and connect to the turbo inlets directly (you don’t want to pressurize the pre-turbo pipes themselves as those run under negative pressure, as they are connected to the turbo inlet not outlet). You need to make sure your throttle is closed (or disconnect at throttle and block the pipe) then pressurize with a compressor. I typically take it beyond max target boost to be sure, and you just listen for leaks and fix them. If you just leave the throttle pipe on and rely on the closed throttle butterfly you may get some leaks there, though should be minimal on a fly by wire car. Thanks! S. |
|
Appreciate
0
|
12-07-2021, 01:19 PM | #6 |
BimmerPost Supporting Vendor
1887
Rep 4,881
Posts |
If sealed properly the charge pipe shouldn't make any difference in sound. The intake should be the only induction sound you hear.
Be sure you installed the o rings and the charge pipe you have fits properly. I have not heard or had any issues with our kit.
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|