| 02-08-2025, 04:31 PM | #1 |
|
Captain
 770
Rep 915
Posts |
Carbon fibre driveshaft flanges ?
Does anyone know if the trans end of the carbon fibre driveshafts between the high and low spline count shafts are compatible? In order to install the csr diff I ordered a used ds off eBay and it showed up without the flange to bolt to the guibo/flex disk. Didn't even know it came off. If anyone knows would appreciate it. Seller is being a dick so wonder if I can pull it off my high spline count shaft.
|
| 02-11-2025, 12:09 PM | #3 |
|
Colonel
 
2464
Rep 2,078
Posts |
Removable flange is only on the version of the propshaft you purchased.
On the current propshaft it is welded.
__________________
M2 Competition 6MT: MCS 3way, Full Kinematics, Drexler diff with custom ramps, Lift Kit, CF Propshaft, 513M 10.5 ET46 Square, CF Recaro's Pole Position, ST2 Hybrid Turbos, Keyed Crank Hub, CCB, Ti Pistons, 1465kg with half of fuel tank,
530hp/580nm. |
|
Appreciate
0
|
Post Reply |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|
