Best way to make a 19x10.5 et42 square set up work

[Pinoyf80]

I recently acquired a set of HRE P101s second hand, but I'm concerned the offsets won't work, especially in the front. Any suggestions on how to achieve the best fitment? Maybe a 20mm spacer in the front? (Not ideal). The car is lowered on KW HAS.

[M3SQRD]

Yes. You’ll need a 20 mm spacer and at least -3.0 deg of camber to make the front fit. A common track setup uses 18x10.5et36 square with 295/30 square tires. A minimum 15 mm spacer is required on the front which results in an effective offset of et21. Depending on your suspension setup, you may need a thicker spacer, or a narrower tire, to prevent rubbing between the tire and strut body/spring seat. Don’t worry about using a thick spacer because the factory-built f82 GT4 race car uses a 31 mm thick front spacer and the factory-built f87 CSR race car uses a 41 mm thick front spacer.