|
Post Reply |
|
Thread Tools | Search this Thread |
01-13-2022, 08:19 PM | #1 |
Lieutenant
306
Rep 419
Posts |
[help] measurement needed - anyone has Bilstein B16 dampers off of the car?
Backstory - I have been running B16 Damptronic with Ground Control camber plate for almost 2 years. The ball bearings in the GC plates are worn out and due for replacement. So I order some newly designed GC slider plate with bearing already pressed in. However, the newly designed slider plate uses a "centering sleeve" to keep the shaft centered in the bearing. But Bilstein damper shaft has a step lip that ground control wasn't aware of. Therefore, the centering sleeve cannot be seated properly on the damper shaft (see pic below)
View post on imgur.com The top bronze thingy is the centering sleeve. The top portion of it goes into the monoball joint View post on imgur.com And right in between the gap (highlighted with red arrows) is the step lip that Ground Control was not aware of, and they do not have the diameter of it. Due to this, the inner diameter of the sleeve is not machined wide enough to sit properly (no gap)... My shop have already re-assembled everything...So does anyone here have a set of B16 (either the regular one or the damptronic one) off of the car, and can measure the diameter of that step lip for me? I would really appreciate the help! FYI - the new slider plate uses a larger diameter monoball joint. So in theory, it should last longer.... View post on imgur.com Last edited by jim1013yyf; 01-13-2022 at 08:32 PM.. |
01-22-2022, 08:16 PM | #2 |
Second Lieutenant
92
Rep 299
Posts |
Do you still need the info? I recently acquired a set of used B16 damptronics but the stock top hat is on it. I will have to take it off since I have the Millway camber plates anyhow. I wasn't planning to install it until later this spring but if you still need the measurements, I should be able to get a spring compressor to remove the top hat and get the measurements for you.
|
Appreciate
0
|
01-22-2022, 08:19 PM | #3 | ||
Lieutenant
306
Rep 419
Posts |
Quote:
Quote:
|
||
Appreciate
0
|
Post Reply |
Bookmarks |
|
|