Autotalent
BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read

Go Back   BMW M3 and BMW M4 Forum > BMW F80 M3 / F82 M4 Technical Topics > Engine / Drivetrain / Exhaust / Bolt-ons / Tuning

Post Reply
 
Thread Tools Search this Thread
      12-08-2017, 08:34 AM   #1
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

F80 M3 w/ Pure Turbos - Full E85 Custom Bootmod3 Dyno Results - 623whp/612wtq

I had a great time testing several configurations yesterday. Hats off to proTUNING Freaks for creating such an incredible tuning platform. I was able to very quickly flash the car using my iPhone connected to the BM3 agent device and use my MacBook to adjust the tunes as needed. I was able to go through many configurations in a very short time thanks to the efficiency of the Bootmod3 tuning platform.

Now for the results. This is a very conservative reading Dynojet so I have included Stock ZCP baselines in every graph below for delta reference.

Car Details: 2016 F80 M3 ZCP w/ 21k miles

Current mods: Pure Stage 2 Turbos, RK Tunes Intake, BMS CP's, MPI Catless DP's, Torqbyte Meth Controller w/ custom lines and BMS Stealth tank.

I used this same Dyno in February while I still had stock turbos so the first graph below is a comparison of the Stock ZCP tune on Stock turbos vs Pure
Turbos. As you can see, at low stock boost pressures the Pure's aren't really even in their efficiency range yet but still gained 20hp up top where it's expected and didn't lose anything down low.

Now for my test sequence.

I started with < 1 gallon of our crappy NW Florida 93octane pump gas.

1. Graph #1 is Stock ZCP map - Stock Turbos vs Pure turbos on 93pump.
2. Graph #2 is Stock ZCP map on Pure Turbos vs My tune on 93pump with Pure Turbos.
(I was happy that my 93 tune follows the same power curve as stock but just much higher output, this is how it feels on the road as well)

After this we filled with full E85.

3. Graph #3 is Stock ZCP vs Full E85 on stock fuel system only. Pure Turbos 26psi with taper.

Now I turned on my Torqbyte Methanol controller and turned up boost to 28psi with less taper to redline.

4. Graph #4 is Full E85 vs Full E85 + Methanol

5. Finally Graph #5 shows where I started in February with Stock ZCP on Stock turbos vs Today's Pure Turbos full E85 + Meth custom BM3 tune.

Next time I plan to focus more time revising and smoothing the full E85 and E85 + meth maps, there is absolutely much more headroom to push the map with Methanol, I haven't even engaged stage 2 on my meth setup yet!
Attached Images
      

Last edited by F80Paul; 12-08-2017 at 12:19 PM..
Appreciate 7
hellokitty2883.50
FSociety3810.00
tom @ eas8056.00
NO_USER_537.50
whoop_ass355.00
      12-08-2017, 10:49 AM   #2
FSociety
IG @bmwF9xG80
FSociety's Avatar
3810
Rep
7,593
Posts

Drives: G80 M3, X4M, G07 X7m50
Join Date: Apr 2012
Location: NYC to NJ to Orlando FL

iTrader: (3)

Garage List
2023 BMW G80 M3  [0.00]
2020 BMW X4MC  [0.00]
16' BMW X4 M40i  [10.00]
06 Cadillac STS  [0.00]
Good job! Bootmod3 FTW
554/556 on Stock Turbo Custom 93oct right?
Appreciate 0
      12-08-2017, 11:14 AM   #3
tom @ eas
BimmerPost Supporting Vendor
tom @ eas's Avatar
United_States
8056
Rep
18,786
Posts


Drives: BMW
Join Date: Nov 2005
Location: Anaheim, CA

iTrader: (19)

Garage List
2018 BMW i3s  [0.00]
2010 BMW M3  [6.50]
2015 BMW M4  [5.25]
Fantastic results. Thanks for providing dynojet numbers.
__________________
Tom G. | european auto source (eas)
email: tom@europeanautosource.com · web: https://europeanautosource.com· tel 866.669.0705 · ca: 714.369.8524 x22

GET DAILY UPDATES ON OUR BLOG · FACEBOOK · YOUTUBE · FLICKR · INSTAGRAM
Appreciate 0
      12-08-2017, 12:11 PM   #4
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

Quote:
Originally Posted by FSociety View Post
Good job! Bootmod3 FTW
554/556 on Stock Turbo Custom 93oct right?
No sir, that is Pure Stage 2 results on 93 pump (which is crap here in NW Florida btw)

The only stock turbo results I posted here are in the first graph where I compare my stock turbo stock zcp map results from February to yesterdays results on Pure with same stock map on same dyno, and the last graph where I compare stock turbo baseline to my best results yesterday on E85 with Pure's. All other graphs are Pure Turbo results.

Last edited by F80Paul; 12-08-2017 at 12:18 PM..
Appreciate 0
      12-08-2017, 12:15 PM   #5
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

Quote:
Originally Posted by tom @ eas View Post
Fantastic results. Thanks for providing dynojet numbers.
Thank you, Tom.
Appreciate 0
      12-08-2017, 02:30 PM   #6
Pure Turbos
Captain
Pure Turbos's Avatar
United_States
563
Rep
681
Posts

Drives: Turbo Cars
Join Date: Nov 2013
Location: Oceanside, CA

iTrader: (0)

This is awesome, Great job Paul
Appreciate 0
      12-08-2017, 02:39 PM   #7
Soofy
Carholics
Soofy's Avatar
United_States
210
Rep
177
Posts

Drives: Z4 GT3
Join Date: Feb 2016
Location: San Diego

iTrader: (0)

Here you go !! #NoPeakingPowerOutHere !
Great job Paul
__________________
Z4 GT3 BodyKit | Pure Turbos | Fuel It | LiteSpeed Racing Wheels | GT250 APR Performance Wing | Studio RSR Rollbar | GTHAUS Meisterschaft turbo back | DinMann CF parts | RECARO CS Sportster | JB4 | CSF Cooling System | Full Custom interior | 2M AutoWerks | Viral vinyl werks | Toyo Tires | Ceramic Pro | Oneighty NYC | DOC Race | M3/M4 BBK | SSP Upgraded Clutches | Custom Coilovers with Hydraulift System By Status Gruppe |
Appreciate 0
      12-08-2017, 02:40 PM   #8
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

Quote:
Originally Posted by Pure Turbos View Post
This is awesome, Great job Paul
Much appreciated, Jesse. These turbos have been flawless!
Appreciate 1
      12-08-2017, 03:15 PM   #9
chetrickerman
ECUTek Master Tuner
chetrickerman's Avatar
United_States
10438
Rep
1,727
Posts

Drives: F80 M3 YMB
Join Date: Jul 2017
Location: Colorado Springs

iTrader: (0)

Garage List
2016 BMW M3  [9.00]
Well done! What boost pressure are the PS2 turbos holding up top?
__________________
Quote:
Torque is a measure of an engine's ability to do work; Power is the rate at which work is done
Appreciate 0
      12-08-2017, 04:06 PM   #10
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

I was asked concerning my 93 pump tune, "Can't the same gains be had with BM3, FBO, and stock turbos?". Weeell, sort of. But not on 93 pump only.

Here is a comparison of the best run at this Dynojet back in Feb with Stock turbos, 93+meth maxed out at 26.5psi vs yesterday's 93 pump only tune on Pure Turbos at 23psi.

Add any amount of meth to the Pure Turbos side of this comparison and it would be no contest. The point is, Pure Turbos do offer an advantage over stockers, even on just pump gas. Stock turbos tuned out on 93 pump only run around 500hp max on this particular dyno.
Attached Images
 
Appreciate 3
FSociety3810.00
      12-08-2017, 05:05 PM   #11
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

Quote:
Originally Posted by chetrickerman View Post
Well done! What boost pressure are the PS2 turbos holding up top?
On the straight E85 tune I held onto about 26 in the middle down to around 21psi at redline.

With E85+meth it was like 28psi still at 6k, then a little taper after that.
Appreciate 0
      12-08-2017, 05:17 PM   #12
chetrickerman
ECUTek Master Tuner
chetrickerman's Avatar
United_States
10438
Rep
1,727
Posts

Drives: F80 M3 YMB
Join Date: Jul 2017
Location: Colorado Springs

iTrader: (0)

Garage List
2016 BMW M3  [9.00]
Quote:
Originally Posted by F80Paul View Post
On the straight E85 tune I held onto about 26 in the middle down to around 21psi at redline.

With E85+meth it was like 28psi still at 6k, then a little taper after that.
Was the boost maxed out up top on the E85+meth?

How did you wire in your meth controller?
__________________
Quote:
Torque is a measure of an engine's ability to do work; Power is the rate at which work is done
Appreciate 0
      12-08-2017, 08:41 PM   #13
whoop_ass
Captain
whoop_ass's Avatar
355
Rep
719
Posts

Drives: non
Join Date: Apr 2013
Location: On Earth

iTrader: (0)

This is great Power Paul, it's no wonder that car posts such fast Vbox numbers because it is fast..
I am sure we going to see 700hp easy with the boost turned up to what you had it before. would love to see what you do at 34psi with Eth and Meth.
DAMN!!

There is zero taper in top end power with the Pure's
they honestly supper efficient at the top..
Stock turbo's start to fall on their face after 6.5k and the pure just keep pulling like a freight train.

Last edited by whoop_ass; 12-08-2017 at 08:46 PM..
Appreciate 1
      12-08-2017, 11:21 PM   #14
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

Quote:
Originally Posted by chetrickerman View Post
Was the boost maxed out up top on the E85+meth?

How did you wire in your meth controller?
Not maxed out up top by any means on meth. This result on E85+meth is very conservative. The straight E85 tune is pushed to the edges of the fuel system limits, but with meth the more volume I spray the more fueling headroom there is. I have yet to explore the limits on my car with E85+meth like I have with 93+meth and race gas+meth.

I use the Torqbyte controller, if you look them up online you can see the many different setups that are possible. I have 2 nozzles post-IC and 2 pre-IC. Setup in 2 stages and I have boost/rpm based pump duty maps setup.
Appreciate 2
FSociety3810.00
      12-09-2017, 07:22 AM   #15
chewbakam4
Major
chewbakam4's Avatar
717
Rep
1,184
Posts

Drives: F82 M4
Join Date: Oct 2015
Location: Malton

iTrader: (0)

Need me some Pure! Really nice numbers! I’d max out mine for pump gas and leave it alone I think.
Appreciate 1
      12-10-2017, 03:25 AM   #16
F80Paul
Second Lieutenant
283
Rep
250
Posts

Drives: 2016 M3 ZCP
Join Date: Dec 2016
Location: NW Florida

iTrader: (0)

Quote:
Originally Posted by chewbakam4 View Post
Need me some Pure! Really nice numbers! I’d max out mine for pump gas and leave it alone I think.
The Pure 93 tune drives surprisingly well for sure!
Appreciate 1
whoop_ass355.00
Post Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 09:56 AM.




f80post
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST