08-19-2021, 03:27 PM | #1 |
Grid.Life
325
Rep 383
Posts |
Rays 57CR 19x10.5 +35 Square
These are in near mint condition, missing one center cap. Selling because they don't fit over my CCB calipers. They are absolutely gorgeous wheels and fit very well with just a little bit of camber and some +25 spacers on the front of the car. These can be transported to any upcoming GridLife events in the Midwest and any event at PittRace. I also have two sets of tires that can be included with these wheel if you are looking to put them on a track car. 295/30/19 Goodyear SuperCar 3 - $700 305/30/19 Bridgestone RE71R - $700 |
09-19-2021, 10:50 AM | #5 |
New Member
16
Rep 24
Posts |
Beautiful wheels! I'm really curious that if you could run 295 fronts without any spacers, I really want to run a square set up from now on but don't really think 275 is wide enough
|
Appreciate
0
|
09-19-2021, 08:47 PM | #6 |
Grid.Life
325
Rep 383
Posts |
You would definitely need a spacer with these wheels on the front, I recommend a 25mm spacer. The rear does not require spacers. I actually ran a 295 for awhile on these, on the racetrack this car needs all the tire it can get.
|
Appreciate
0
|
09-20-2021, 02:21 PM | #7 |
New Member
16
Rep 24
Posts |
It really does, I'm running 275 fronts NT01 on the fronts on a set of 9.5j ze40, I just can't run anything wider on the wheel and it frustrates me. With MDM on I'm not getting mush slips in the rear but lots of under steer in front. I would definitely look into your getting your wheels after I'm done with my current set of tires. Btw is running 25mm on track safe? I've seen some guys wheels fallen off when driving hard on track.
|
Appreciate
0
|
09-20-2021, 09:26 PM | #8 |
Grid.Life
325
Rep 383
Posts |
I only use the Turner extended hub style spacers. I actually use this 7.5mm spacer with another 17.5mm Turner spacer.
https://www.ecstuning.com/b-turner-m...f8005j08black/ https://www.ecstuning.com/b-turner-m...r/twhf9905f18/ |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|