Snow Performance Water/Meth Install. Found a good place for the VC-50 Controller.

[Twistm4]

Those of you using jb4 or a progressive controller. What settings are you using for your START FLOW psi and FULL FLOW psi?

[tomlong]

Where can I buy the blue pales of race grade methanol?

My meth setup was just installed. Also went with Snow Performance (braided lines option) + two #5 nozzles placed on the cold side of EOS Charge Cooler and also using the Burger-tuning 3-gallon reservoir tank.

My VC-50 controller is currently just sitting in the driver side storage compartment and I'm just waiting for the 52mm air vent gauge pod to come from Taiwan. I ordered 2 of them just in case the plastic is brittle or I break one by accident during the gauge install.

Car is currently under the knife for w/EU5 injectors, Bend Calibration Ultimate Flex Fuel and PnP CANbus wiring harness so I haven't drove the car yet.

[hellokitty]

Is it possible just to use distilled water with these systems without meth?

I like the idea of cooling charge air similar to the GTS but I've always been hesitant to run meth+water.

[b_w.]

reviving an old thread. with the snow vc50 controller where are you installing the provided map / boost sensor for the controller? or how are you hooking it up? I am going to spray water into the j pipe so was thinking of pulling from the charge pipe. I also have the boost tap for the map sensor on the tmic but would have to run a vaccum line and then tie in the sensor. Appreciate some feedback on how others have done it.

[Ak665]

Originally Posted by b_w.

reviving an old thread. with the snow vc50 controller where are you installing the provided map / boost sensor for the controller? or how are you hooking it up? I am going to spray water into the j pipe so was thinking of pulling from the charge pipe. I also have the boost tap for the map sensor on the tmic but would have to run a vaccum line and then tie in the sensor. Appreciate some feedback on how others have done it.

Retweet

Me to think how to put the VC-5 boost pressure waiting for any answer

[b_w.]

Originally Posted by Ak665

Retweet

Me to think how to put the VC-5 boost pressure waiting for any answer

I used a do88 j pipe with dual meth bungs. Used a 90 degree fitting to mount the sensor and the nozzle in the other.

[b_w.]

Pics attached