New MAD Product Release S55 Single MidPipe & Brace

[j-roc]

Are these in stock? Best price to 77469 please

[Info@mad-us.com]

Originally Posted by j-roc

Are these in stock? Best price to 77469 please

Our shipping is free to the lower 48 for all orders

[j-roc]

Non resonated please

[Info@mad-us.com]

Originally Posted by j-roc

Non resonated please

You have PM

[Dareem_7777]

Hi please quote me for high flow catted downpipe and single midpipe for f82 please

[Info@mad-us.com]

Originally Posted by Dareem_7777

Hi please quote me for high flow catted downpipe and single midpipe for f82 please

You have PM

[Idfkman]

Originally Posted by Info@mad-us.com

You have PM

You guys still planning to do a F8X axle back exhaust?

[Info@mad-us.com]

Originally Posted by Idfkman

You guys still planning to do a F8X axle back exhaust?

We got a few things on our plate at the moment but maybe after those products are complete.

[Dsmdrew]

Price for m3 comp to 98498

[Info@mad-us.com]

Originally Posted by Dsmdrew

Price for m3 comp to 98498

Not allowed to post prices here. You have pm.

[M3FANN]

I have been super happy with my setup.

Mad catless fat-boy downpipes/single mid, and MP rear section on a bm3 stage 2 tune.

Installation:
-Installation was straight forward. The larger downpipes really are a snug fit getting them in. Once everything was aligned and tightened up I have zero vibrations/leaks.
Sound:
-Startup with the cat delete isn't loud enough to disturb the neighborhood(I have tuned out the cold start). Has a deep sound in low rpm with a lot of turbo noise. It is raspy at high rpm/WOT. Inside the car with windows up, it is quite tame and very little drone if any. I only experience the smell with windows down or sitting idle for a while, I personally don't mind it. Once the valves open the sound is insane...
-I am looking to add a resonator to the single mid pipe. Do you offer one like you have for the g80?
I will eventually get around to making a video with sound clips.

[Info@mad-us.com]

Originally Posted by M3FANN

I have been super happy with my setup.

Mad catless fat-boy downpipes/single mid, and MP rear section on a bm3 stage 2 tune.

Installation:
-Installation was straight forward. The larger downpipes really are a snug fit getting them in. Once everything was aligned and tightened up I have zero vibrations/leaks.
Sound:
-Startup with the cat delete isn't loud enough to disturb the neighborhood(I have tuned out the cold start). Has a deep sound in low rpm with a lot of turbo noise. It is raspy at high rpm/WOT. Inside the car with windows up, it is quite tame and very little drone if any. I only experience the smell with windows down or sitting idle for a while, I personally don't mind it. Once the valves open the sound is insane...
-I am looking to add a resonator to the single mid pipe. Do you offer one like you have for the g80?
I will eventually get around to making a video with sound clips.

Thanks for the review.

Unfortunately, we do not sell a stand alone resonator but, it sounds like it would help a little with the top end rasp you are experiencing from the mp rear exhaust. Mp exhausts do tend to rasp since they were not designed with downpipes in mind.

[mike@x-ph.com]

Originally Posted by M3FANN

-I am looking to add a resonator to the single mid pipe. Do you offer one like you have for the g80?
I will eventually get around to making a video with sound clips.

We offer Vibrand resonators which will help with your setup.

[viperguy212]

Anyone with this installed get a good amount of drone at 2k rpm? I installed mine two weeks ago and higher rpm’s its fine but they highway crusing range has a pretty bad drone to the point where I find myself closing the flaps. This may just be an S55 thing.

[JAI///M3]

No drone here. OEM downpipes, MAD mid pipe no resonators, ZCP muffler. Full disclosure though, I’m old and have dabbled with hot rods for years, so my acceptable threshold for drone is likely higher than most.

[Info@mad-us.com]

Originally Posted by JAI///M3

No drone here. OEM downpipes, MAD mid pipe no resonators, ZCP muffler. Full disclosure though, I’m old and have dabbled with hot rods for years, so my acceptable threshold for drone is likely higher than most.

[Cowsgomoo1284]

Installed MAD charge pipes and midpipe over the weekend. Sounds incredible, easy install and good quality. Ordered from Extreme Powerhouse. Highly recommend

[Info@mad-us.com]

Originally Posted by Cowsgomoo1284

Installed MAD charge pipes and midpipe over the weekend. Sounds incredible, easy install and good quality. Ordered from Extreme Powerhouse. Highly recommend

Glad you like it. Thanks for the review!

[Dsmdrew]

Originally Posted by Info@mad-us.com

For the Mpe you will need to cut your Mpe Midpipe to allow it to connect with our clamps.

Our midpipe will not connect to the axle back part of the muffler directly.

Is there any instructions for this. I have an mpe and don't want to cut the wrong spot

[Info@mad-us.com]

Originally Posted by Dsmdrew

Is there any instructions for this. I have an mpe and don't want to cut the wrong spot

No instructions for the mpe but here is where you should cut.


https://f80.bimmerpost.com/forums/sh....php?t=1290556