07-20-2018, 08:33 PM | #1 |
Private First Class
25
Rep 115
Posts |
F32/F82 Tail Light Swap Issue (F32LCI T2)
So I went to swap my LCI tail lights from my F32 to my F82 after reading everywhere they would fit, but the guide "pin" would not line up on the inside lights (I even contacted EAS where I got them and they said they were direct swap).
The pin seemed to be about 1/8 too high but rather then trying to sell them and buy a new set of F82 LCI's I ended up just cutting them off, with the intention of moving the pin with some epoxy. So far they seem to be holding up ok without the pin but I can tell they are like 1/16th of an inch high on the outsides where the guide pin would keep them in place. Not sure if it was an issue with the P/N (F32LCI T2 LI) or anyone know?
__________________
2016 X3 Alpine White
*sold* 2017 M4 6MT Sakhir Orange : ZCP//CCB//BM3//LCI *sold* 2014 435i 6MT xdrive : JB4//LCI |
07-28-2018, 04:27 PM | #2 |
Lieutenant Colonel
1466
Rep 1,637
Posts |
F32 and f82 inner taillight not compatible. I had the same issue and caused the water leak inside taillight and trunk.
All you did is what I did exactly 4 months ago passed though rain season without issue after cutting off the guide pins. |
Appreciate
1
reighnman25.00 |
07-29-2018, 09:13 PM | #4 | |
Private First Class
25
Rep 115
Posts |
Quote:
Seems silly
__________________
2016 X3 Alpine White
*sold* 2017 M4 6MT Sakhir Orange : ZCP//CCB//BM3//LCI *sold* 2014 435i 6MT xdrive : JB4//LCI |
|
Appreciate
0
|
08-31-2019, 12:28 PM | #5 |
No 55mph
1619
Rep 8,476
Posts |
However, when you install F82 into F32 all fits as it should. Put F82 LCI tails in my F32 yrs ago. No trimming needed and no leaks
Last edited by 1QuikWS6; 08-31-2019 at 04:45 PM.. |
Appreciate
0
|
02-14-2021, 01:39 PM | #6 |
Lieutenant Colonel
724
Rep 1,756
Posts |
This is an old thread, but there is no way in hell that that little alignment dowel would cause a water leak. The lip on the edge and the plastic clamp should keep the light tight enough to the body to prevent water intrusion. The dowel does not press fit into the trunk lid, nor does it hold the lamp snug to the trunk lid.
__________________
2016 428ix, r, 2018 430iC, 2018 330it
|
Appreciate
0
|
04-21-2021, 12:27 AM | #7 |
Registered
0
Rep 2
Posts |
Hello. I have F32, and I bought f82 lci tail lights. After installed the taillights and washed the car water comes into the trunk tail lights. So I need to cut off small plastic pin on taillight to solve the trouble?
|
Appreciate
0
|
10-05-2023, 12:05 AM | #8 |
New Member
5
Rep 22
Posts
Drives: BMW 2016 F82 ZCP
Join Date: May 2023
Location: Seattle
|
How did it go? Does it fit ok after removing the guide?
|
Appreciate
0
|
11-08-2023, 09:12 AM | #9 |
Colonel
910
Rep 2,091
Posts |
I just cut the tab off fully, I run f32 tails on my f82
__________________
MGM F82 M4 DCT / MPerformance / Swift / CSF / IND / Turner / BimmerWorld
BSM F87 M2 6MT / Fabspeed / MPerformance / Turner / AutoID - SOLD JB-NB E92 M3 6MT / IND / RTD / Alpine / KW / ActiveAutowerke / 360Carbon - SOLD SS2-FR E90 M3 6MT / IND / AFE / ActiveAutowerke - SOLD AW-FR E90 M3 DCT / ACM / IND / AutoTecknic / K&N / H&R / Bilstein - SOLD |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|