06-27-2019, 04:28 PM | #1 |
Captain
528
Rep 855
Posts |
ZCP stock ride height measurements needed
Hi Guys,
Anyone have the measurements in mm for the stock ZCP ride height (front and back) so I can compare with? The measurement is done from the center of the lower lip of the wheels to the center of the fender crease (just underneath). Here are my measurements (note that I have CS EDC) and that there is half a tank of gas and no one in the car. Front Right: 651mm Front Left: 652mm Rear Right: 622mm Rear Left: 621mm Rake is approx: 30mm front to back Steve |
06-30-2019, 04:31 PM | #3 | |
Captain
528
Rep 855
Posts |
Quote:
Thanks for the feedback. I assume you're running the recommended height from the MP HAS instructions or something else? Here are the recommended MP HAS heights for 20" rims: FR: 633mm RR: 626mm |
|
Appreciate
0
|
07-03-2019, 02:25 PM | #4 |
Private First Class
55
Rep 193
Posts |
I am set lower, running camber plates, and corner balanced.
LF: 626 RF: 629 LR: 620 RR: 620 a little lower that what I would like. they were set based off of 19’s which has some differences than if set based on 20’s, even when the rim difference is taken into account. |
Appreciate
0
|
07-03-2019, 10:26 PM | #5 | |
Captain
528
Rep 855
Posts |
Quote:
20" rims fr/rr): RF: 628 RR: 619 Is that the lowest that MP HAS can go or is there more room? Do you feel the springs on the MP HAS are stiffer or softer than your ZCP springs that you had before? |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|