04-22-2018, 01:47 PM | #1 |
Major
377
Rep 1,168
Posts |
Question on CF upper splitter fitment
I bought these and installed with double sided tape.
The issue on both sides is the tapered tip does not sit flush. I tried using VHB 3M red backed tape but at .46mm it is a bit thick and causes the splitter point to not be flush. What epoxy or glue would one suggest that would bond almost immeeiately as clamping it is not possible. I know it will pull paint off when I remove but it really looks like shit not being flushed at the end. |
07-18-2018, 11:21 AM | #4 |
Brigadier General
5392
Rep 3,737
Posts
Drives: 2016 M4 DCT Tanzanite/Amaro
Join Date: Oct 2016
Location: Princeton
|
|
Appreciate
0
|
07-18-2018, 06:03 PM | #6 |
Out in the middle of the sea
231
Rep 471
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|