Ferodo Break Pad Problem

[erik_m3g80]

Hey guys,

yesterday I did the retrofit to the big break of the M2C 6/4 Pot.
In the Front I use the Ferodo DS Perfomance Pads. Now I have the problem that the original and the TRW wear sensor doesn’t fit to the break pad. The problem is that the Piece (braket holder?) where I have to put the sensor inside is thicker than the two sensors which I tried to use. Did someone had maybe the same problem and can tell me which sensor I can use?

Best regards

Erik

[erik_m3g80]

Nobody? :-(

[fanatic1]

Hid them up and out of the way using zip ties. Keeping an eye on them is not that difficult.

[Tommy L Garage]

Agreed. You don’t need sensors. Zip tie them away

[erik_m3g80]

This is what I did but I thought there is a perfect solution for the sensors