04-08-2021, 03:13 AM | #1 |
Enlisted Member
13
Rep 35
Posts |
Stuck in limp mode help!
Car has been running and sounding great then out of no where DriveTrain Malfunction error no hard pulls just started the car then a few minutes later after driving not even a mile the car 428i 2016 went into to LIMP MODE here are the codes:
I am thinking it can be a bad MAF sensor hopefully or Charge pipe failure. I took a look at the charge pipe from eyes view looks to be intact along with everything else. But I'm stuck in this limp mode not being able to drive past 20 MPH unless going down hill. Car still sounds good, no hard idle, starts fine. What should I be looking for? Last edited by mediaone1; 04-08-2021 at 03:14 AM.. Reason: spelling |
04-08-2021, 07:39 AM | #2 |
Major General
1837
Rep 6,990
Posts
Drives: 15 F80 M3, 22 G01 X3 30i
Join Date: Apr 2010
Location: Clayton, NC
|
You're in the wrong forum - try the F3x forum in the 328/428 N20 engine section.
__________________
2015 F80 ///M3 Sedan 7DCT Tanzanite, 2022 X3 sDrive30i 8AT Brooklyn Grey |
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
limp, limp mode, mode |
|
|