What did you do to your M3/M4 today?

[shiny_f_80]

plugged it in to the trickle charger in the garage

[Thekidhodges]

Added Eventuri Charge Pipes, Engine Cover, R44 Carbon Radiator Support and Mosselman Thermo.

[Rokoz]

Originally Posted by michael1284

New wheels.

Those brakes

[Clarkie52]

Had a nice autumn bath while it was a nice day.

[BadBoostedBMWM3]

Originally Posted by NickyC

My fav mod ever. The car is truly done now.

Very nice!

Is there some type of custom bracket or connection or what is exactly needed?

[NickyC]

Originally Posted by BadBoostedBMWM3

Very nice!

Is there some type of custom bracket or connection or what is exactly needed?

Thanks, and nope. Rails/mounting points are exactly the same between the two cars. So is the one electrical connection plug. Takes 10-15 minutes to swap seats out, install, and have everything hooked up. Only thing then needed is to code the G82 seats to remove the airbag light.

I unfortunately had to remove the G82 seats after using them for just a bit. I'm far too big, the leg bolsters were killing me. Luckily, I was able to sell them to a local guy and got my money back. It's very disappointing however, I adored the way the way the looked in the car. Except for the leg bolsters, they were very comfortable, and I liked the lower seating position they provided opposed to the stock F82 seats. Quite the bummer.

[Rockshaker]

Originally Posted by EezyBeezy

Thanks to EzeyBeezy post on the euro headlight switch, I finally got my hands on the euro spec F8X headlight switch. When I was in the UK, the dealer refused to sell it to me without VIN registered in the UK. I picked one from Mperformance in Australia 🇦🇺 😀 Shipping took 2 weeks.

[EezyBeezy]

Originally Posted by Rockshaker

Thanks to EzeyBeezy post on the euro headlight switch, I finally got my hands on the euro spec F8X headlight switch. When I was in the UK, the dealer refused to sell it to me without VIN registered in the UK. I picked one from Mperformance in Australia 🇦🇺 😀 Shipping took 2 weeks.

Happy to help & share. Cheers!

[couchflyer]

I installed the GC Precision VSC-2 - Variable Sound Controller exhaust valve controller. I purchased the default one, which is automatic (factory control), and activated is open.

I like this mod more than I thought it would.

.

[Slow M3]

Removed and reinstalled the side skirts because I didn’t do it properly first time so rocks kept getting stuck between the side skirt and rocker panel.

Been “dealing” with it like that for over a year plus because of the pain in the ass to remove the old tape from the the side skirt. Finally did it, it sucked balls but it’s finally done with a rubber wheel and drill.

[Clarkie52]

Give the M4 what should have been a quick contactless wash,but after rinsing the foam off I found black marks all over it due to recent fireworks going off.Give it a bucket wash with Labocosmetica Purifica which removed the marks.

[jackgreer]

Just got some KWV3’s from a forum member and added macht schnell spacers with the new suspension. Currently sitting as low as I feel comfortable in Los Angeles streets with 10 rear and 12 front.

This is 1000 times better of a drive than H&R springs

[Charlesm924]

Installed Alcatera cover and m perf carbon trim

[Slow M3]

Installed ghost subs and OEM euro side mirrors. Side mirrors are weird at first couple glances, but you eventually get used to them lol.

[274lafayette]

Installed MST intakes

[Jim45678]

Originally Posted by Slow M3

Installed ghost subs and OEM euro side mirrors. Side mirrors are weird at first couple glances, but you eventually get used to them lol.

Any real difference with Subs comparing to standard ones? I assume you have HK setup? Have you upaded the amp as well on running on OEM?

[Slow M3]

Originally Posted by Jim45678

Any real difference with Subs comparing to standard ones? I assume you have HK setup? Have you upaded the amp as well on running on OEM?

Yes, HK setup and OEM amp. It’s still in break in but you can definitely feel the difference in how the bass hits. It’s cleaner and less thumpy/muddy. According to Bav we don’t need to swap amps since the subs are tuned to the amp.

[Alex77586]

Installed Turner Motorsport Axle back today paired with AA EQL non-resonated Mid section.

[cptclutch]

Finally pulled the trigger on swapping out my coils/plugs. Feels good (minus the back pain)!

[essjon]

Replaced my front sway bar

[Slow M3]

Originally Posted by essjon

Replaced my front sway bar

This is going to be my next mod! What brand did you go with? And do you feel a drastic difference in front end feel?

[essjon]

Originally Posted by Slow M3

This is going to be my next mod! What brand did you go with? And do you feel a drastic difference in front end feel?

I went with whiteline. The car is much flatter around turns and more planted. Very cost effective modification!


https://whitelineperformance.com/pro...BoCMS4QAvD_BwE