08-05-2024, 05:02 PM | #1 |
Enlisted Member
3
Rep 34
Posts |
Help Misfire in all cylinders
Hi, anyone know why all of a sudden I am getting codes upon start up on misfires on ALL cylinders?
Bad gas? It all happened at once. I could see a cylinder here and there for a bad sparkplug or even MAF or even coils. But if it were one of those, I would assume it would be limited to 1 bank. Anyone have any ideas the engine only has about 4k miles on it.
__________________
Performance: BM3 Stage 2 and Jordan tune, VRSF Downpipe, Active Autowerks Mid Pipe, Competition Exhaust, BMS Charge Pipes, RK Autowerk Carbon Fiber Front Mount Intakes
KW Variant 3 Suspension, Rogue Short Shifter Kit Exterior :All RW Carbon all around & Bayoptiks headlight/tails. |
08-06-2024, 05:44 AM | #4 |
General MacArthur
5453
Rep 406
Posts
Drives: 2017 Ferrari Red F80
Join Date: May 2016
Location: Bay Area
|
Blown intercooler?
I had check engine followed by several cylinder misfiring and car went into lip mode. Was over due for plugs so thought was only that and check codes and codes told me fluid was low and check and it was. Changed plugs and coils last night and Wagner intercooler goes on tomorrow. So I guess my advice would be check the codes?
__________________
https://www.instagram.com/ferrariredm3/
2017 ///M3 Individual Ferrari Red / Full Black Leather/ ZCP / DCT |
Appreciate
0
|
08-06-2024, 08:54 AM | #5 |
Enlisted Member
3
Rep 34
Posts |
thanks codes just said misfire in cylinder 1,2,3,4,5,6. No additional codes were found. I have a BM3 tune with a a jordan tune on top. Maybe the plugs have run too hot, however I do have the gapped to Jordans specs and running the colder plugs. I would not expect them to fail at just 4k miles.
__________________
Performance: BM3 Stage 2 and Jordan tune, VRSF Downpipe, Active Autowerks Mid Pipe, Competition Exhaust, BMS Charge Pipes, RK Autowerk Carbon Fiber Front Mount Intakes
KW Variant 3 Suspension, Rogue Short Shifter Kit Exterior :All RW Carbon all around & Bayoptiks headlight/tails. |
Appreciate
0
|
08-06-2024, 01:13 PM | #6 |
Captain
593
Rep 727
Posts |
i just ran into this issue with my 6mt. could be your dual mass flywheel is failing. Mine was registering misfires on every cylinder which is unusual. is it rattling at all from the middle of the car? It would be ok if I was on throttle but as soon as I went partial it would toss all the codes. Didnt rattle like crazy at first but got really bad. if it vibrates enough check that your crank pulley bolts dont loosen and start wobbling.
|
Appreciate
0
|
08-06-2024, 02:06 PM | #7 | |
BimmerPost Supporting Vendor
2644
Rep 5,863
Posts |
Quote:
__________________
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
misfires |
Thread Tools | Search this Thread |
|
|