Stance Air Cups Installed on my M4 (KW V3)

[todd20]

Hey guy just wanted to share my experience on my new Stance Cup I installed on my KW v3 coil overs. I got the front lift kit with the air compressor (no tank) to save room since my F83 doesn't have too much room to spare already.

TANKLESS FRONT KIT
Shaft diameter front: 22mm
+
Adapters / spacers - 91mm x 121mm, 15mm thick (To mate with my GC camber plates)

The install was pretty easy for the most part.

For my install I needed to change my springs since my KW v3's had progressive springs and I needed linear ones.

I got two springs from Eibach
0800.250.0250 ERS LINEAR MAIN SPRING






I ran the air tube from the drivers side to the passenger side through the top of the engine. See Pics.







From the passenger side they connect to a y-plug that goes through the passenger side rocker panel, over the wheel well, and to the truck where the battery is located.







The tube then goes under the trunk area and to the opposite side of the battery where my amplifier was. This is where I put my wiring since it have a lot of room. I put the compressor in the back of my trunk and ran all the wires under the carpet and back into my amplifier area.









I chose to put my on/off button right under my radio unit for a nice OEM look



Here is a final video of how it looks and works for anyone whose interested. See it around 1:20

--------------

[todd20]

Sorry I have no idea why some of the pictures are sideways

[michael1284]

How long does it take to reach max height?

[todd20]

Originally Posted by michael1284

How long does it take to reach max height?

about 5 seconds

[Eighty8M]

nice to see another type of Cupkit set up!

I did Fortune Auto Coilovers with Stanceparts