ZCP stock ride height measurements needed

[stevehifi]

Hi Guys,

Anyone have the measurements in mm for the stock ZCP ride height (front and back) so I can compare with?

The measurement is done from the center of the lower lip of the wheels to the center of the fender crease (just underneath).

Here are my measurements (note that I have CS EDC) and that there is half a tank of gas and no one in the car.

Front Right: 651mm
Front Left: 652mm
Rear Right: 622mm
Rear Left: 621mm

Rake is approx: 30mm front to back

Steve

[CRRobert]

I measured 652 front and 622 rear on mine, ‘18 F80 ZCP, stock 20” rims. I am running on MP HAS now.

[stevehifi]

Originally Posted by CRRobert

I measured 652 front and 622 rear on mine, ‘18 F80 ZCP, stock 20” rims. I am running on MP HAS now.

Thanks for the feedback. I assume you're running the recommended height
from the MP HAS instructions or something else?

Here are the recommended MP HAS heights for 20" rims:
FR: 633mm
RR: 626mm

[CRRobert]

I am set lower, running camber plates, and corner balanced.
LF: 626
RF: 629
LR: 620
RR: 620
a little lower that what I would like. they were set based off of 19’s which has some differences than if set based on 20’s, even when the rim difference is taken into account.

[stevehifi]

Originally Posted by CRRobert

I am set lower, running camber plates, and corner balanced.
LF: 626
RF: 629
LR: 620
RR: 620
a little lower that what I would like. they were set based off of 19’s which has some differences than if set based on 20’s, even when the rim difference is taken into account.

That's essentially what the GTS runs on the track height setting (assuming
20" rims fr/rr):
RF: 628
RR: 619

Is that the lowest that MP HAS can go or is there more room?

Do you feel the springs on the MP HAS are stiffer or softer than your ZCP springs that you had before?

[matty088]

Love to know if mp has feels stiffer?