10-08-2019, 09:39 AM | #23 |
Lieutenant Colonel
123
Rep 1,503
Posts |
The front gap between the hood and the front bumper can be evened out if you loosen the top torque screws of the bumper and then tighten them while holding/pushing the bumper up.
Happened to me when i was installing my eventuri intake. After the install it looked all out of whack but after pulling the bumper up and tightening (making sure everything is even) it made the gap smaller and uniform across the front. |
Appreciate
1
Taco_Bueno955.50 |
10-10-2019, 07:01 PM | #24 | |
Captain
956
Rep 624
Posts |
Quote:
It got to the point that everytime I looked at my car that gap was all I saw. |
|
Appreciate
0
|
10-14-2019, 11:43 AM | #25 |
Lieutenant Colonel
123
Rep 1,503
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|