Chassis stabilization errors. Reset icm??

[matty088]

I lowered my car mp has. Every now and then I get an error for chassis stabilization. Usually happens when stopped or going slow. I never reset the icm. Is thsg the reason. I don’t think I damaged anything with the install. How do I reset the icm ?

Seems like it’s necessary anyway

[matty088]

Alex form alpine was nice enough to remotely log in and check my codes. This isn’t icm recalibratjon related. It seems sensor related in the front left strut. Weird how it goes in and out. I get an error. Cycle the car on off and it goes away. I checked the connection. Unplugged it. And reconnected it. The wire seems fine as well.
Does anyone have a thought ?

[matty088]

Codes

[maddmatth]

Replace the sensor. It's probably just faulty.

[matty088]

Ill start there.

If the actual strut is damaged would the error be the same ? I am not sure if the sensor is actually functioning correctly and just telling us the strut is bad.

[knightarmor]

Loose connection or bad sensor. Since you say you already checked the connection the sensor may be bad.

[DJM4]

Replace the sensor. I just did on my 2015 M4.

[SteveChester]

Originally Posted by DJM4

Replace the sensor. I just did on my 2015 M4.

Is the part number for the EDC sensor - 31312284780?

I keep getting the occasional chassis warning which goes away with a check off / on again!

[SteveChester]

Or is it the "cable acclerating sensor"?

[gprzybylski]

I replaced the sensor also and 2 days later got the same error code. Turn the car off and back on goes away then randomly comes on when the car is off and I restart it and move 10 feet.

[sicck_m4]

Originally Posted by gprzybylski

I replaced the sensor also and 2 days later got the same error code. Turn the car off and back on goes away then randomly comes on when the car is off and I restart it and move 10 feet.

What app is this that reads the code?