10-12-2019, 12:45 PM | #1 |
Second Lieutenant
![]() ![]() 75
Rep 285
Posts
Drives: 2017 M3 Comp
Join Date: May 2014
Location: Sweden
|
M3/M4 CS EDC coding with Bimmercode?
Hello,
Is it possible to use Bimmercode to code M4 GTS and/or CS EDC settings on an F80 ZCP? Thanks |
10-20-2019, 09:23 AM | #2 |
Private First Class
![]() 121
Rep 134
Posts |
It may be possible to fdl code the settings with BimmerCode if the vehicle i-step level is new enough. I’m not sure that BimmerLink will be able to perform edc start up procedure (or others) if you run into that fault after coding however.
I documented the values you can try to fdl code in expert mode in the diy guide validation section at https://f80.bimmerpost.com/forums/sh....php?t=1649232. This is written for coding with esys and Ista+ however. |
Appreciate
0
|
10-20-2019, 09:28 AM | #4 | |
Second Lieutenant
![]() ![]() 75
Rep 285
Posts
Drives: 2017 M3 Comp
Join Date: May 2014
Location: Sweden
|
Quote:
|
|
Appreciate
0
|
12-19-2019, 07:08 PM | #7 |
Brigadier General
![]() 162
Rep 3,151
Posts |
|
Appreciate
0
|
01-01-2020, 10:28 AM | #8 |
Private First Class
![]() 42
Rep 140
Posts
Drives: F80, G01
Join Date: Jan 2006
Location: Raleigh
|
There was a thread about the Thor app here but it's been removed. Any reason why? I was trying to find out more information about the app. I was looking to do some coding as well.
|
Appreciate
1
jbed39.50 |
01-10-2020, 06:45 PM | #10 |
Lieutenant
![]() ![]() ![]() ![]() 309
Rep 595
Posts |
Yes. I used Thor for GTS tuning for the DCT, steering, diff, MDM, etc and Carly for all the usual coding like iDrive warnings, mirror folding, and all that other stuff.
|
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
bimmercode, code, coding, f80, zcp |
|
|